- -$0.50
- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Reference: DWM15010504
Brand: Semtech
The RFM69CW /RFM69HCW are built in by SX1231and SX1231H which is ISM Free band transceiver module capable of operation over a wide frequency range, including the 433MHz,868MHz and 915MHz.
The OLG02 is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
OLG02 is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular. The
LoRa wireless allows users to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity.
OLG02 has Rich Internet Connection method such as WiFi interface, Ethernet port and USB host port. These Interfaces provide flexible methods for users to connect their sensor networks to Internet.
OLG02 can support the LoRaWAN protocol in single frequency and customized LoRa transmit protocol. The design of OLG02 is use the Linux to directly control two sx1276/sx1278 LoRa modules which lets the LoRa can works in full duplex LoRa mode and increase the communication efficiency.
OLG02 can be used to provide a low cost IoT wireless solution to support 50~300 sensor nodes.
Except LoRaWAN mode, OLG02 can support mutiply working mode such as: LoRa repeater mode, MQTT mode, TCP/IP Client mode, TCP/IP Server mode to fit different requirement for IoT connection. Click this link for more info about the modes.
OLG02 base on sx1276 solution which provide a low cost for your IoT network connection. Compare to the cost with normal SX1301 LoRaWAN solution. OLG02 is only of its 1/4 or less cost. This make the OLG02 very suitable to set up small scale LoRa network or use it to extend the coverage of current LoRaWAN network.
Indoor Version: LG02-XXX-YY.
Outdoor Version: OLG02-XXX-YY.
-XXX:
433: Best Tuned at 433Mhz
868: Best Tuned at 868Mhz
915: Best Tuned at 915Mhz
EC25-AU: with Quectel EC25-AU for Latin America, New Zeland, Taiwan
EC25-E:with Quectel EC25-E for EMEA, Korea, Thailand, India.
EC25-A: with Quectel EC25-A for North America/ Rogers/AT&T/T-Mobile.
EC25-J: with Quectek EC25-J for Japan, DOCOMO/SoftBank/ KDDI
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14033102
Brand: Semtech
The RFM96W / RFM98W 433MHz,470MHz transceivers feature the LoRaTM long range modem It's from the HopeRF LoRa module.build by the semtech chipset with the application for ARM meters.
Reference: DWM15091402
Brand: Semtech
The RFM92W /RFM95W transceivers with 868 MHz and 915 MHz feature the LoRa TM long range rf module which core chipset are the semtech serice LoRa chipset,usually build for the ARM application.
Reference: DWM17112001
IOT LoRa Gateway 4G Module is Quectel EC25 which is with Adaptor Board and used in the LG01-S and OLG01 IOT LoRa Gateway as bridge of 4G cellular wireless network.
Reference: DWM16122201
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: ODL25022003
The SPH01-NB is an NB-IoT Soil pH Sensor for IoT of Agriculture. It is designed to measure the soil PH and soil temperature, to send to the platform to analyze the soil acid or alkali level.
Reference: ODL23091203
PS-LB-NA convert the Analog Value to LoRaWAN wireless data and send to IoT platform via LoRaWAN gateway. supports BLE configure and wireless OTA update.
Reference: DWM17111102
MS14N-S Linux IoT / VoIP Appliance With Sensor Terminal is to solve the connectivity problem and greatly enhance micro-controller products such as the Arduino.
Reference: DWM18110501
LG308 8 Channels Indoor LoRaWAN Pico Gateway is an open source LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: ODL24090101
LMS01-LS is a LoRaWAN Leaf Moisture Sensor for IoT of Agriculture Powered by a solar panel Supports BLE configuration and wireless OTA update which makes users easy to use.
Reference: ODL23103105
The LMS01-LB LoRaWAN Leaf Moisture Sensor Supports BLE configure and wireless OTA update for IoT of Agriculture it is designed to measure the leaf moisture and temperature to analyze the leaf status such as: watering, moisturizing, dew, frozen.
Reference: ODL22110602
The Dragino LLDS40 is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor for Internet of Things solution. It is capable of measuring the distance to objects as close as 0m to 40m. The LiDAR probe uses laser induction technology for distance measurement.
Reference: ODL24082701
ES-261520 3.6V 8500mAh Li/ SOCI2 Battery for Dragino IOT sensor nodes like the SN50-V3, SN50v3-D20, DDS75-LB, SE01-LB,20, SN50-LB-S31 ext.
Reference: ODL23042103
The LHT65S-NE117 Temperature & Humidity sensor is a Long Range LoRaWAN Sensor use an external probe uses TI TMP117A NIST traceability temperature sensor, with 0.1°C accuracy in normal temperature range.
Reference: ODL25011302
WSS-08 Optical Rain Guage The Optical Rain Guage for the WSC2-L Weather Station Kit is a weather monitor instrument to monitor rainfall.
Reference: ODL24062202
LG01v2 uses Open Source Linux system design for peer to peer single channel LoRa protocol instead of LoRaWAN protocol,lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet or Cellular Network (via Optional 4G module).
Reference: ODL23102004
The LDS12-LB LoRaWAN LiDAR ToF Distance Sensor supports BLE configure and wireless OTA update be use to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection.
Reference: ODL22071403
The GroPoint is a LoRaWAN Multi Soil Segment Converter It is designed to connect to GroPoint Profile Multi-depth Soil moisture and temperature profile Sensor for IoT of Agriculture.
Reference: DWM21051603
The LSNPK01 is a LoRaWAN Soil NPK Sensor for IoT of Agriculturebase. detects soil's Nitrogen, Phosphorus, and Potassium use TDR method, and uploads these values via wireless to LoRaWAN IoT Server.
Reference: ODL23042104
The LHT65S-E2 Temperature & Humidity sensor is a Long Range LoRaWAN Sensor. It includes a built-in Temperature & Humidity sensor and has an external sensor connector to connect to an external Temperature Sensor.
The OLG02 is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.