- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Reference: DWM15010504
Brand: Semtech
The RFM69CW /RFM69HCW are built in by SX1231and SX1231H which is ISM Free band transceiver module capable of operation over a wide frequency range, including the 433MHz,868MHz and 915MHz.
ER14250+SPC1520 Super Pulse Cap 1200mAh Li/SOCI2 unchargable battery for IOT Sensor nodes.
Reference: DWM17112003
LSN50 - Waterproof Long Range Wireless LoRa Sensor Node is an open source product, it is based on the STM32Cube HAL drivers and lots of libraries can be found in ST site for rapid development.
Reference: DWM18101201
The OLG02 is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular.
Reference: DWM19090402
The LPS8 is an open source LoRaWAN Gateway Build in SX1308 and SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: DWM20033101
ER18505+SPC1520 Super Pulse Cap 4000mAh Li/SOCI2 unchargable battery for LSN50 Sensor nodes.
Reference: ODL23103101
The CPL03-LB is a LoRaWAN Contact Sensor that detects open/close status and uplinks to the IoT server via the LoRaWAN network. Users can see the dry contact status, open time, and open counts in the IoT Server.
Reference: DWM21072702
The LSN50V2-S31B is LoRaWAN Temperature & Humidity Sensor node be used to measure the surrounding environment temperature and relative air humidity for IoT solution.
Reference: ODL25021502
The D23-LS is a solar-powered LoRaWAN Temperature Sensor designed for waterproofing/Outdoor use The temperature sensor used in D23-LS can measure -55°C ~125°C with accuracy ±0.5°C (max ±2.0 °C).
Reference: ODL23110104
WSS-02 is a RS485 wind speed and wind direction monitor designed for weather station solution.
Reference: ODL23110101
The LDS40-LB is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection supports BLE configure and wireless OTA update.
Reference: ODL24082701
ES-261520 3.6V 8500mAh Li/ SOCI2 Battery for Dragino IOT sensor nodes like the SN50-V3, SN50v3-D20, DDS75-LB, SE01-LB,20, SN50-LB-S31 ext.
Reference: ODL24090101
LMS01-LS is a LoRaWAN Leaf Moisture Sensor for IoT of Agriculture Powered by a solar panel Supports BLE configuration and wireless OTA update which makes users easy to use.
Reference: ODL25011303
WSS-09 9 in 1 Sensor for Dragino WSC2-l Weather Station solution measures the below values: Wind Speed, Wind Direction, Temperature, Humidity, Air Pressure, Illumination, PM2.5, PM10, Noise & Rain Gauge.
Reference: ODL24082902
TrackerD-LS is a Solar Powered LoRaWAN Asset Tracker based on ESP32 MCU that gets the location data via GPS and sets it to an IoT server via the LoRaWAN network. supports Motion Detection this feature will save power when no motion is detected.
Reference: DWM21010104
The LSN50v2-S31 is a LoRaWAN Temperature and Humidity Sensor for Internet of Things solution. It is used to measure the surrounding environment temperature and relative air humidity precisely, and then upload to IoT server via LoRaWAN wireless protocol.
Reference: DWM20031101
Brand: Semtech
DWM-SL1276 868MHz /915MHz sx1276 LoRa transceiver RF module compatible with RFM95W which core chipset are the semtech SX1276 LoRa chipset,usually build for the ARM application.
Reference: DWM17111105
OV1 WIFi Outdoor IoT Appliance is an VoIP appliance designed for transfer the Voice over long distance WiFi connection.
Reference: DWM20090101
LoRa Antenna-BLG-AN-040-868MHz /915MHz Glass Fiber antenna for LoRaWAN Gateway LoRa IoT Application.
Reference: DWM18112902
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM20030401
Dragino LoRa IoT Development Kit is designed to facilitate beginners and developers to quickly learn LoRa and IoT technology.it will show how to build LoRa network, and how to use the network to send data from a LoRa sensor node to the cloud server.
Reference: ODL25030203
PS-NB-T NB-IOT Thread Installation LoRaWAN Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
ER14250+SPC1520 Super Pulse Cap 1200mAh Li/SOCI2 unchargable battery for IOT Sensor nodes.