- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Reference: DWM15010504
Brand: Semtech
The RFM69CW /RFM69HCW are built in by SX1231and SX1231H which is ISM Free band transceiver module capable of operation over a wide frequency range, including the 433MHz,868MHz and 915MHz.
LG02-P is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
LG02-P is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular. The LoRa wireless allows users to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity.
LG02-P has Rich Internet Connection method such as WiFi interface, Ethernet port and USB host port. These Interfaces provide flexible methods for users to connect their sensor networks to Internet.
LG02-P can support the LoRaWAN protocol in single frequency and customized LoRa transmit protocol. The design of LG02-P is use the Linux to directly control two sx1276/sx1278 LoRa modules which lets the LoRa can works in full duplex LoRa mode and increase the communication efficiency.
LG02-P can be used to provide a low cost IoT wireless solution to support 50~300 sensor nodes.
Except LoRaWAN mode, LG02-S can support mutiply working mode such as: LoRa repeater mode, MQTT mode, TCP/IP Client mode, TCP/IP Server mode to fit different requirement for IoT connection. Click this link for more info about the modes.
LG02-P base on sx1276 solution which provide a low cost for your IoT network connection. Compare to the cost with normal SX1301 LoRaWAN solution. the LG02-S is only of its 1/4 or less cost. This make the LG02-P very suitable to set up small scale LoRa network or use it to extend the coverage of current LoRaWAN network.
Linux Side:
Cellular 4G LTE (optional):
Indoor Version: LG02-XXX-YY.
Outdoor Version: OLG02-XXX-YY.
-XXX:
433: Best Tuned at 433Mhz
868: Best Tuned at 868Mhz
915: Best Tuned at 915Mhz
EC25-AU: with Quectel EC25-AU for Latin America, New Zeland, Taiwan
EC25-E:with Quectel EC25-E for EMEA, Korea, Thailand, India.
EC25-A: with Quectel EC25-A for North America/ Rogers/AT&T/T-Mobile.
EC25-J: with Quectek EC25-J for Japan, DOCOMO/SoftBank/ KDDI
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14033102
Brand: Semtech
The RFM96W / RFM98W 433MHz,470MHz transceivers feature the LoRaTM long range modem It's from the HopeRF LoRa module.build by the semtech chipset with the application for ARM meters.
Reference: DWM17112001
IOT LoRa Gateway 4G Module is Quectel EC25 which is with Adaptor Board and used in the LG01-S and OLG01 IOT LoRa Gateway as bridge of 4G cellular wireless network.
Reference: DWM18072401
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
Reference: ODL24082901
SN50V3-LS Solar Powered LoRaWAN Sensor Node It is designed for outdoor use and powered by a solar panel + li-on battery for long-term use. It Supports BLE configuration and wireless OTA updates.
Reference: DWM18120401
Brand: Semtech
DWM-LJ1295 868MHz /915MHz sx1276 LoRa transceiver RF module compatible with RFM95W which core chipset are the semtech SX1276 LoRa chipset,usually build for the ARM application.
Reference: ODL25030404
The CPL03-NB is an NB-IoT Contact Sensor for Internet of Things solution. it detects dry contact status, open time, and open counts, and then uploads to the IoT server via NB-IoT network supports BLE configuration and OTA update.
Reference: DWM20090102
The NBSN95 is a Long Range NB-IoT Sensor Node is used NBSN95 to rapidly deploy NB-IoT sensor node for their IoT solution.
Reference: ODL25030203
PS-NB-T NB-IOT Thread Installation LoRaWAN Air /Water Pressure Sensor that can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the NB-IOT server.
Reference: ODL23102003
The MDS200-LB is a LoRaWAN Microwave Radar distance sensor supports BLE configure and wireless OTA update which use 24Ghz Microwave to detect the distance between the sensor and different objects.
Reference: ODL23103102
The RS485-LB is a RS485 / UART to LoRaWAN Converter for Internet of Things solutions. User can connect RS485 or UART sensor to RS485-LB converter, and configure RS485-LB to periodically read sensor data and upload via LoRaWAN network to IoT server.
Reference: DWM21051605
The LSPH01 LoRaWAN Soil pH Senso for IoT of Agriculture it is designed to measure the soil PH and soil temperature to analyze the soil acid or alkali level IP68 waterproof.
Reference: ODL22071402
The LG308N is an open source Linux LoRaWAN Pico Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular network.
Reference: DWM21061002
The NBSN95A is a Long Range NB-IoT Sensor Node is used the Quectel BC35-G module to rapidly deploy NB-IoT sensor node for IoT solution.
Reference: DWM17111102
MS14N-S Linux IoT / VoIP Appliance With Sensor Terminal is to solve the connectivity problem and greatly enhance micro-controller products such as the Arduino.
Reference: ODL25022601
The MDS200-LS is a solar-powered LoRaWAN Microwave Radar distance sensor. It uses a 24Ghz Microwave to detect the distance between the sensor and different objects. Microwave Radar is more reliable for condensation / dusty environments than ultrasonic or Lidar measurement methods.
Reference: ODL22100701
The LoRa IoT Kit v3 can be used to evaluate the multi-channel LoRaWAN solution and single-channel private LoRa solution. Users can also use LoRa IoT Kit v3 to test different network structure solutions and find the best for their IoT solution.
Reference: ODL22051403
HP0D is Outdoor LoRaWAN gateway it supports the miner feature from Helium and has a built-in ATECC608 encryption chip. It can be used as a Helium Full Hotspot for the project.
Reference: ODL25030201
PS-NB-D NB-IoT Differential Pressure Sensor uses Differential Pressure Sensor includes various models to cover NB-IoT wireless transmission and different ranges of pressure measurements.
Reference: ODL23110101
The LDS40-LB is a LoRaWAN LiDAR ToF (Time of Flight) Distance Sensor can be applied to scenarios such as horizontal distance measurement, parking management system, object proximity and presence detection supports BLE configure and wireless OTA update.
LG02-P is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.