- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Reference: DWM15010504
Brand: Semtech
The RFM69CW /RFM69HCW are built in by SX1231and SX1231H which is ISM Free band transceiver module capable of operation over a wide frequency range, including the 433MHz,868MHz and 915MHz.
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 3G or 4G cellular. The LoRa wireless allows users to send data and reach extremely long ranges at low data-rates. It provides ultra-long range spread spectrum communication and high interference immunity.
LG02-S has Rich Internet Connection method such as WiFi interface, Ethernet port and USB host port. These Interfaces provide flexible methods for users to connect their sensor networks to Internet.
LG02-S can support the LoRaWAN protocol in single frequency and customized LoRa transmit protocol. The design of LG02-S is use the Linux to directly control two sx1276/sx1278 LoRa modules which lets the LoRa can works in full duplex LoRa mode and increase the communication efficiency.
LG02-S can be used to provide a low cost IoT wireless solution to support 50~300 sensor nodes.
Except LoRaWAN mode, LG02-S can support mutiply working mode such as: LoRa repeater mode, MQTT mode, TCP/IP Client mode, TCP/IP Server mode to fit different requirement for IoT connection. Click this link for more info about the modes.
LG02-S base on sx1276 solution which provide a low cost for your IoT network connection. Compare to the cost with normal SX1301 LoRaWAN solution. the LG02-S is only of its 1/4 or less cost. This make the LG02 very suitable to set up small scale LoRa network or use it to extend the coverage of current LoRaWAN network.
Linux Side:
Cellular 4G LTE (optional):
Indoor Version: LG02-XXX-YY.
Outdoor Version: OLG02-XXX-YY.
-XXX:
433: Best Tuned at 433Mhz
868: Best Tuned at 868Mhz
915: Best Tuned at 915Mhz
-YY:
EC25-AU: with Quectel EC25-AU for Latin America, New Zeland, Taiwan
EC25-E:with Quectel EC25-E for EMEA, Korea, Thailand, India.
EC25-A: with Quectel EC25-A for North America/ Rogers/AT&T/T-Mobile.
EC25-J: with Quectek EC25-J for Japan, DOCOMO/SoftBank/ KDDI
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14033102
Brand: Semtech
The RFM96W / RFM98W 433MHz,470MHz transceivers feature the LoRaTM long range modem It's from the HopeRF LoRa module.build by the semtech chipset with the application for ARM meters.
Reference: DWM16092702
The Lora/GPS_HAT is an expension module for LoRaWan for using with the Raspberry Pi.This product is intended for those interested in developing LoRaWAN solutions which is based on the SX1276/SX1278 transceiver.
Reference: DWM17112001
IOT LoRa Gateway 4G Module is Quectel EC25 which is with Adaptor Board and used in the LG01-S and OLG01 IOT LoRa Gateway as bridge of 4G cellular wireless network.
Reference: ODL23091206
The DDS45-LB is a LoRaWAN Distance Detection Sensor that supports BLE configuration and wireless OTA update which uses ultrasonic sensing technology for distance measurement for the Internet of Things solution.
Reference: DWM21051607
The Dragino RS485-LN is a RS485 / UART to LoRaWAN Converter. It converts the RS485 and UART devices into LoRaWAN wireless network which simplify the IoT installation and reduce the installation/maintaining cost.
Reference: DWM20090102
The NBSN95 is a Long Range NB-IoT Sensor Node is used NBSN95 to rapidly deploy NB-IoT sensor node for their IoT solution.
Reference: DWM21031502
The DWM-AR9331 is a minimal system which installed with OpenWrt Linux system and support 2.4G WiFi It is compatible with 802.11b/g/n.widely use as an IoT gateway core modules.
Reference: DWM19090402
The LPS8 is an open source LoRaWAN Gateway Build in SX1308 and SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: ODL23103002
The PS-LB-T or PS-LB-I sensors are LoRaWAN Pressure Sensors for the Internet of Things solution. PS-LB can measure Air, Water pressure, and liquid levels and upload the sensor data via wireless to the LoRaWAN IoT server.
Reference: ODL25011301
DS20L LoRaWAN smart distance detector is fully compatible with LoRaWAN v1.0.3 Class A protocol, it can work with a standard LoRaWAN gateway which measures a range between 3cm ~ 200cm.
Reference: ODL25021901
The TC11-LB used in the K-Type thermocouple can measure -50°C ~ 200°C. TC01-LB has 2 open wires so the user can connect a 3rd party K, J, N, R, S T, E, or B-type thermocouple.
Reference: DWM20033101
ER18505+SPC1520 Super Pulse Cap 4000mAh Li/SOCI2 unchargable battery for LSN50 Sensor nodes.
Reference: DWM18110801
Build your own LoRaWAN "The Things Network" packet-forwarding gateway on Windows 10 IoT Core in native .NET code.
Reference: DWM17102701
RF Explorer - ISM Combo Handheld Digital Spectrum Analyzer is a very affordable tool for work in all ISM popular frequency bands.
Reference: DWM18022201
Dragino LoRa IoT Development Kit is designed to facilitate beginners and developers to quickly learn LoRa and IoT technology.it will show how to build LoRa network, and how to use the network to send data from a LoRa sensor node to the cloud server.
Reference: DWM16122201
The 433MHz /868MHz /915MHz Arduino LoRa Shield is a long range transceiver on a Arduino shield form factor and based on Open source library.Compatible with Arduino Leonardo, Uno, Mega, DUE.
Reference: DWM20072901
The DLOS8 Outdoor LoRaWAN Gateway includes 1pcs SX1301 and 2pcs SX1257 LoRa Tranceiver which provide 10 programmable parallel demodulation paths.
Reference: ODL23110103
WSC2-LB is the Main Process Unit for Weather Station solution which is full compatible with LoRaWAN Class C protocol, it can work with standard LoRaWAN gateway.
Reference: DWM20030401
Dragino LoRa IoT Development Kit is designed to facilitate beginners and developers to quickly learn LoRa and IoT technology.it will show how to build LoRa network, and how to use the network to send data from a LoRa sensor node to the cloud server.
LG02-S is an open source dual channels LoRa Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet, 4G cellular.