- On sale!

Reference: DWM14042301
Spring antenna is specialized for wireless data transmission. This antenna with good performance of V.S.W.R, small size design, easily installation, stable performance and good anti-shock and anti-aged compatible for Hoperf Modules.
Reference: DWM14032902
SMA rf antenna connector is pallets copper gold andexternal thread needle sma pallets plate rf connector.
Reference: DWM14032102
Whip antenna for sub-1 GHz, 433MHz,868MHz and 915MHz with SMA male connectors.it's used with wireless module recommanded by Hoperf .
Reference: DWM14042401
SMA RG178 extension female cable for GPS, GSM antenna,RF module, SMA cable,IPEX to SMA jumper cable.
Reference: DWM18032302
USD3.0/pcs MOQ100pcs LoRa Antenna designed for Lora application which required for outdoor waterproof highgain and work at ISM free band like 433MHz /868MHz /915MHz SMA Male Whip antenna.
Reference: DWM16121503
DWM-TLB-3.0QB SUB-1GHz / 2.4GHz Whip antenna with a Collapsible SMA male connectors.Which are available for 433MHz,868MHz.915MHz and 2.4GHz..
Reference: DWM15101001
Brand: Semtech
RFM50 module series’ design is based on the high performance RF50 SoC chip, It include a CIP-51 core‘ MCU and 100mW transceiver. It operate at 433/470/868/915 MHz ISM band, comply with FCC, ETSI regulation.
Reference: DWM15010504
Brand: Semtech
The RFM69CW /RFM69HCW are built in by SX1231and SX1231H which is ISM Free band transceiver module capable of operation over a wide frequency range, including the 433MHz,868MHz and 915MHz.
The DWM-RAK7204 is an LPWAN node that serves as an environmental monitoring station. The high-precision sensors, can measure changes in temperature, humidity, gas pressure and provide an indoor air quality index.
Working Temperature
Parameter |
Min |
Typical |
Max |
Operating Temperature |
-40℃ |
+25℃ |
+85℃ |
Storage Temperature |
-40℃ |
+25℃ |
+85℃ |
Power Consumption
Parameter | Current | Unit |
Standby Current | <15 | uA |
Current in Sensors Working Mode | <10 | mA |
Current in LoRa® Transmission Mode | <150 | mA |
Temperature Sensor Specifications
Parameter | Min | Typical | Max |
Temperature Range | -40℃ | +25℃ | +85℃ |
Accuracy | 0.5℃ | ||
Output Resolution | 0.01℃ |
Humidity Sensor Specifications
Parameter | Min | Typical | Max |
Humidity Range | 0% r.H | 100 % r.H. | |
Accuracy | +-3% r.H. | ||
Output Resolution | 0.008% r.H. |
Gas Pressure Sensor Specifications
Parameter | Min | Typical | Max |
Range | 300 hPa | 300 hPa | |
Accuracy | +-0.6 hPa | ||
Output Resolution | 0.18 Pa. |
IAQ Sensor Specifications
Parameter | Min | Typical | Max |
IAQ Range | 0 | 500 | |
Accuracy | 15 | ||
Output Resolution | 1 |
1. The included battery is non-rechargeable. In case you need to plug in the Micro USB port for the purpose of configuring the node, the battery should stay plugged.Note :
2. The pin distance of the battery connector is 2.0mm. When choosing a battery, attention should be paid to the consistency of positive and negative poles. Reverse connections or short circuits may damage the device and may cause overheating and combustion of the battery. Therefore, when replacing the battery, it is necessary to strictly confirm whether the positive and negative poles of the connector are correct.
Hello. What are the specifications for the antenna? I can see X0454-X2 written on it,
but Dr Google provides no answers.
No idea, honestly it is probably a decent antenna, as with most LoRa nodes. I would not expect it to be better than 1dB :
( This is what you get from a patch that you want to fit inside a small box. However, I can stay testing is it proved to be decent,
guess LoRa does really help with range, We cover our office no problem through walls, etc. I haven't done a line of sight test,
but I am pretty sure it will do a couple of kilometers. I mean this is meant as a smart building device, so you would expect it
to be relatively close to the router.
What are the interval for sending data and the SF that needs to be configured to achieve the expected 2 years o
f operation with the battery? I need 5 minutes interval with at least SF10 (better SF11). Will it last > 2 years?
The battery life of more than 2 years is expected if you are transmitting at 15-minute data transmission intervals.
This being said it will most definitely not last 2 years if you are transmitting in 5 min intervals. I think the SF, in this case,
will be irrelevant as the time interval alone will reduce the battery life significantly.However this is a prediction based on a
shorter period of operation, we have no way to test it for a 2-year interval, so it might be possible,
however, we can not claim it :)
Is there any description of the jumpers in the device? Thanks!
We are finalizing the document, apologies. Could you please post your request on the forums,
I think they will be able to help there.
https://forum.rakwireless.com
Hi, where can I find a payload decoder for this device for TTN? Thanks!
I am not sure there is one yet. Could you please post your question on the forums: forum.rakwireless.com
Better have the whole community be aware, perhaps someone can provide a solution I can not.
Reference: DWM17111202
LoRaST 433MHz /470MHz /868MHz /915MHz Open Source Long Range Wireless LoRa Transceiver is a small wireless transceiver module offers a very compelling mix of long range, low power consumption and secure data transmission.
Reference: DWM17112003
LSN50 - Waterproof Long Range Wireless LoRa Sensor Node is an open source product, it is based on the STM32Cube HAL drivers and lots of libraries can be found in ST site for rapid development.
Reference: DWM18122601
DWM-RAK5205 LoRa Tracker built on SX1276 LoRaWAN modem with low power micro-controller STM32L1, integrated the GPS module is an open all source code products, allowing users to link to the LoRaWAN network conveniently.
Reference: DWM19090401
The Dragino LHT65 Temperature & Humidity sensor is a Long Range LoRaWAN Sensor with an external sensor connector can be used for more than 10 years.
Reference: DWM18011801
DWM-RAK83 433MHz/ 868MHz/ 915MHz SX1301 LoRa/ LoRaWAN Gateway Module combine a host system like Raspberry Pi or WisAP(OpenWRT based) or WisCam to help you realize the whole Lora system development.
Reference: ODL22052402
RAK2011 is Arduino shield board powered by the Quectel BG96 modem chipset. It supports 2G/EGPRS, 4G/LTE Cat-M1 (eMTC), Cat-NB1 (Nb-IoT), as well as GPS.
Reference: DWM20053001
Brand: Semtech
The DWM-RAK4260 LPWAN Module is based on Microchip’s ATSAMR34J18B integrating a 32-bit ARM Cortex -M0+ MCU with a LoRa Transceive, provides a number of highly configurable peripherals (configurable as I2C/SPI/UART interfaces).
Reference: DWM20061601
Brand: Semtech
DWM-RAK4200 LPWAN Evaluation Board is a WisBlock product consisting of RAK4200 LPWAN Module and RAK5005 WisBase includes an STM32L071 MCU and SX1276 LoRa® chip that complies with the LoRaWAN® 1.0.2 protocols.
Reference: DWM19091601
RAK7205 LoRa Tracker built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM20060102
Brand: Semtech
DWM-RAK4200 Breakout Module is specifically designed to allow easy excess to the pins on the module in order to simplify development and testing.it's utilized is of an Xbee form factor.
Reference: DWM18050301
DWM-RAK813 LoRa and Bluetooth Module nRF52832 and LoRa SX1276 core chip which is a combination of the BLE and LoRa of the relay node module.
Reference: DWM19022001
DWM-RAK7249 is The Enterprise DIY outdoor LoRaWan GATEWAY Builtin OpenWRT OS support 16 channel LoRa/4G/WIFI/GPS .
Reference: DWM19070801
LoRa Antenna-433MHz /470MHz /868MHz /915MHz 5.8dBi Glass Fiber Antenna with N Female Connector. Out Door Waterproof Fiberglass Antenna which is designed for Lora application required for high gain outdoor waterproof.
Reference: DWM20060201
The IoT Wireless ear tag sensor build by BDDBTECH offers a completed solution for the dairy farm Management system.
Reference: DWM18011701
RAK811 LoRa module complies with the latest LoRaWAN Class A & C protocol specifications, it is simple to access LWPA IOT platforms integrates SX1276 and stm32L with TELEC CE FCC KCC certification.
Reference: DWM20053101
Brand: Semtech
DWM-RAK4200 LPWAN Module includes an STM32L071 MCU and an SX1276 LoRa® chip. It has an ultra-low power consumption of 1.5uA in sleep mode and high LoRa® output power up to 19dBm max in work mode.
Reference: DWM19091702
RAK2247 LoRa Gateway mPCIE Board-RAK833 Concentrator Module is the evolution of RAK833 is a LoRaWAN gateway Module based on SX1301,Pre-install LoRa gateway OS.
Reference: DWM19070805
RAK7205 LoRa Tracker With Solar Panel built on RAK5205 integrated the Ublox Max 7Q module built on SX1276 LoRaWAN modem with low power micro-controller STM32L1.
Reference: DWM19030101
DWM-RAK7243 Pilot Gateway Pro Kit with Cellular & GPS modules for PoC Raspberry Pi 3B+, RAK2245 Pi HAT,RAK2013 Cellular Pi HAT.
Reference: DWM19070803
RAK7258 Micro Gateway is a full 8-channel LoRa Gateway with built-in Ethernet connectivity for a straightforward setup. Additionally, there is an onboard Wi-Fi setup that allows it to be easily configured via the default Wi-Fi AP mode.
The DWM-RAK7204 is an LPWAN node that serves as an environmental monitoring station. The high-precision sensors, can measure changes in temperature, humidity, gas pressure and provide an indoor air quality index.